モアーウィップ
I bet you anything that katakana is wrong~ Regardless, yes, I have been busy trying to build up my stuff in prep for painting.... But damn, California has been hit with a friggin Arctic storm, and is cold... Tis what we get for laughing at those back east.... Regarldess~
Oh damn~ I knew a day for this gunpla would come... So way back when, i bought one of these and Rasiel, except I didn't like Rasiel (it's the head...). So I've been holding it for quite sometimes, and the day has finally come to try it out...
This time, I was listening to Ms Kawada Mami's new single "See visionS" I have not seen her older ones past "Joint", but I like her songs...
=P -All probably thanks to To Aru Majutsu no Index...
That series and it's spin off is about to be a serious money drain if I don't watch myself....
((And Tsuchimikado Maika is my favorite~ And no one can have her~))
This is what I was trying to do with my Sefer (courtesy of Dengki, of course, and Gundam Wikia for scanning).
I always wondered how you would do that, until I realized this slit....
A blogger called "ゼルえもん" did a combination, which made me wonder.....
Yep, I did it... and as such, now I need a stand....
Is waiting for two stands to be built.... Stupid connector got in the way and couldn't use one of the base stands. Hence, I needed to build two...
Anyone who built the GN Sefer know what the hell you do to actually make this look right? I am very puzzled, since ゼルえもん got it snug fit in his picture
Where my other stand went...
If you guys didn't understand what I said, it's right here....
Usually when I build I either listen to/watch stand-up comedy
Do I need 2 or more GN Sefer just to do that?
yes, at least for that configuration.
You can drill holes into the Proto Bits, and stack more of those on them...
It's called modding.. He modified the Sefer for it to fit. Modding can be achieved through many means. Very basic would be using a combination of putty, pla-plate and the use of a hobby knife.
you sure? even the mockup designs of some of the GN Sefer connection on the Dengeki show snug fit too
From what I recall GN Sefer was released way before Avalanche Exia.. So yeah, it might not fit
but it still utilizes the Exia base frame (and especially since I am using the cone GN Drive)